HP 5900 series - Save money when printing photos

Usage gu
enables the switch to immediately remove a port from the forwarding entry for a multicast
ave message.
This command and the fast-leave command in IGMP-snooping view have the same function but different
fect on all ports.
rt, the igmp-snooping fast-leave command takes priority over the fast-leave command in
s
igabitEthernet 1/0/1.
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] igmp-snooping fast-leave vlan 2
Related c
fast-leave (IGMP-snooping view)
igmp-snooping general-query source-ip
ing general-query source-ip to configure the source IP address for IGMP general
ries.
y source-ip to restore the default.
do igmp-snooping general-query source-ip
Default
e IP address of IGMP general queries is the IP address of the current VLAN interface. If the
s not have an IP address, the source IP address is 0.0.0.0.
Views
Predefine
Usage guide
VLAN before you execute this command.
l
idelines
This feature
group when the port receives a le
effective ranges:
• The fast-leave command in IGMP-snooping view takes ef
• The igmp-snooping fast-leave command takes effect on the current port.
For a po
IGMP-snooping view.
Example
# Enable fast-leave processing for VLAN 2 on Ten-G
<Sysname> system-view
ommands
Use igmp-snoop
que
Use undo igmp-snooping general-quer
Syntax
igmp-snooping general-query source-ip ip-address
un
The sourc
current VLAN interface doe
VLAN view
d user roles
network-admin
Parameters
ip-address: Specifies an IP address.
lines
You must enable IGMP snooping for a
Examples
# In VLAN 2, enable IGMP snooping, and configure 10.1.1.1 as the source IP address of IGMP genera
queries.
<Sysname> system-view
22