HP 5900 series Command Reference

Examples
t the IGMP general query interval to 20 seconds.
igmp-snooping
e
-interval 20
Related c
ing view)
configure a source IP address for IGMP reports.
Use undo igmp-snooping report source-ip to restore the default.
Syntax
undo igmp-snooping report source-ip
Default
ddress of IGMP reports is the IP address of the current VLAN interface. If the current VLAN
ot have an IP address, the source IP address is 0.0.0.0.
les
Usage gu
r a VLAN before you execute this command.
Examples
nfigure 10.1.1.1 as the source IP address of IGMP reports.
igmp-snooping
[Sysname-vlan2] igmp-snooping enable
[Sysname-vlan2] igmp-snooping report source-ip 10.1.1.1
# In VLAN 2, enable IGMP snooping, and se
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enabl
[Sysname-vlan2] igmp-snooping query
ommands
• enable (IGMP-snoop
• igmp-snooping enable
• igmp-snooping max-response-time
• igmp-snooping querier
• max-response-time
igmp-snooping report source-ip
Use igmp-snooping report source-ip to
igmp-snooping report source-ip ip-address
The source IP a
interface does n
Views
VLAN view
Predefined user ro
network-admin
Parameters
ip-address: Specifies a source IP address for IGMP reports.
idelines
You must enable IGMP snooping fo
# In VLAN 2, enable IGMP snooping, and co
<Sysname> system-view
[Sysname]
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
32

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)