[Sysname-acl-basic-2000] rule permit source 225.1.1.1 0
] igmp-snooping group-policy 2000 vlan 2
ommands
igmp-snooping host-aging-time
st-aging-time to set the aging timer for the dynamic member ports in a VLAN.
undo igmp-snooping host-aging-time to restore the default.
ping host-aging-time interval
-snooping host-aging-time
Default
Views
Predefine
Paramete
Usage guide
AN.
y the following formula:
MP general query interval ] + [ maximum response time for IGMP general queries ]
l ] × 2 + [ maximum response time for IGMP general queries ]
time command in IGMP-snooping view have the same function but
ges:
takes effect on all VLANs.
fect on the current VLAN.
ost-aging-time command takes priority over the host-aging-time
Ex
snooping, and set the aging timer for the dynamic member ports to 300
seconds.
[Sysname-acl-basic-2000] quit
[Sysname] interface ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1
Related c
group-policy (IGMP-snooping view)
Use igmp-snooping ho
Use
Syntax
igmp-snoo
undo igmp
The default setting is 260 seconds.
VLAN view
d user roles
network-admin
rs
interval: Sets an aging timer for the dynamic member ports in a VLAN, in the range of 1 to 8097894
seconds.
lines
You must enable IGMP snooping for a VLAN before you execute this command for the VL
To avoid mistakenly deleting multicast group members, set the aging timer for dynamic member ports to
be greater than the value calculated b
[ IG
HP recommends that you set the aging timer of dynamic member ports to the value calculated by the
following formula:
[ IGMP general query interva
This command and the host-aging-
different effective ran
• The host-aging-time command in IGMP-snooping view
mp-snooping host-aging-time command takes ef• The ig
For a VLAN, the igmp-snooping h
command in IGMP-snooping view.
amples
# In VLAN 2, enable IGMP
25
To Next Page
Loading...
Need help?
General
