mld enable
Use mld enable to enable MLD on an interface.
Use undo mld enable to disable MLD on an interface.
Syntax
mld enable
undo mld enable
Default
MLD is disabled on all interfaces.
Views
Interface view
Predefined user roles
network-admin
Usage guidelines
This command takes effect only when IPv6 multicast routing is enabled. If the interface belongs to a VPN
instance, make sure IPv6 multicast routing is enabled on the VPN instance.
MLD configurations on an interface take effect only when MLD is enabled on the interface.
Examples
# Enable IPv6 multicast routing, and enable MLD for VLAN-interface 100 on the public network.
<Sysname> system-view
[Sysname] ipv6 multicast routing
[Sysname-mrib6] quit
[Sysname] interface vlan-interface 100
[Sysname-Vlan-interface100] mld enable
Related commands
ipv6 multicast routing
mld fast-leave
Use mld fast-leave to enable fast-leave processing on an interface.
Use undo mld fast-leave to disable fast-leave processing on an interface.
Syntax
mld fast-leave [ group-policy acl6-number ]
undo mld fast-leave
Default
Fast-leave processing is disabled. The MLD querier sends MLD multicast-address-specific or
multicast-address-and-source-specific queries after receiving MLD done messages.
Views
Interface view
282
To Next Page
Loading...
Need help?
General
