To Next Page

To Previous Page

IPv6 PIM commands

The term "interface" in this chapter collectively refers to VLAN interfaces and Layer 3 Ethernet interfaces.

You can set an Ethernet port as a Layer 3 interface by using the port link-mode route command (see

Layer 2—LAN Switching Configuration Guide).

bidir-pim enable (IPv6 PIM view)

Use bidir-pim enable to enable IPv6 BIDIR-PIM.

Use undo bidir-pim enable to disable IPv6 BIDIR-PIM.

Syntax

bidir-pim enable

undo bidir-pim enable

Default

IPv6 BIDIR-PIM is disabled.

Views

IPv6 PIM view

Predefined user roles

network-admin

Usage guidelines

This command takes effect only when IPv6 multicast routing is enabled.

Examples

# Enable IPv6 multicast routing on the public network, and enable IPv6 BIDIR-PIM.

<Sysname> system-view

[Sysname] ipv6 multicast routing

[Sysname-mrib6] quit

[Sysname] ipv6 pim

[Sysname-pim6] bidir-pim enable

Related commands

ipv6 multicast routing

bidir-rp-limit (IPv6 PIM view)

Use bidir-rp-limit to configure the maximum number of RPs in BIDIR-PIM.

Use undo bidir-rp-limit to restore the default.

Syntax

bidir-rp-limit limit

undo bidir-rp-limit

299

Other manuals for HP 5900 series

Questions and Answers:

Need help?

Do you have a question about the HP 5900 series and is the answer not in the manual?

General