Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command enables IP multicast routing on
the public network.
Usage guidelines
Other Layer 3 multicast commands take effect only when IP multicast routing is enabled.
The switch does not forward multicast packets before IP multicast routing is enabled.
Examples
# Enable IP multicast routing and enter MRIB view on the public network.
<Sysname> system-view
[Sysname] multicast routing
[Sysname-mrib]
# Enable IP multicast routing and enter MRIB view in the VPN instance mvpn.
<Sysname> system-view
[Sysname] multicast routing vpn-instance mvpn
[Sysname-mrib-mvpn]
reset multicast forwarding event
Use reset multicast forwarding event to clear statistics for multicast forwarding events.
Syntax
reset multicast [ vpn-instance vpn-instance-name ] forwarding event
Views
User view
Predefined user roles
network-admin
Parameters
vpn-instance vpn-instance-name: Specifies an MPLS L3VPN instance by its name, a case-sensitive string
of 1 to 31 characters. If you do not specify a VPN instance, the command clears statistics for the multicast
forwarding events on the public network.
Examples
# Clear statistics for the multicast forwarding events on the public network.
<Sysname> reset multicast forwarding event
Related commands
display multicast forwarding event
reset multicast forwarding-table
Use reset multicast forwarding-table to clear the multicast forwarding entries.
83
To Next Page
Loading...
