Predefined user roles
network-admin
Parameters
interval: Sets an MLD last listener query interval in the range of 1 to 25 seconds.
Usage guidelines
The MLD last listener query interval determines the interval for sending MLD multicast-address-specific
queries and the maximum response time for MLD multicast-address-specific queries.
This command and the mld-snooping last-listener-query-interval command have the same function but
different effective ranges:
• The last-listener-query-interval command in MLD-snooping view takes effect on all VLANs.
• The mld-snooping last-listener-query-interval command takes effect on the current VLAN.
For a VLAN, the mld-snooping last-listener-query-interval command takes priority over the
last-listener-query-interval command in MLD-snooping view.
Examples
# Set the global MLD last listener query interval to 3 seconds.
<Sysname> system-view
[Sysname] mld-snooping
[Sysname-mld-snooping] last-listener-query-interval 3
Related commands
mld-snooping last-listener-query-interval
max-response-time (MLD-snooping view)
Use max-response-time to set the global maximum response time for MLD general queries.
Use undo max-response-time to restore the default.
Syntax
max-response-time interval
undo max-response-time
Default
The global maximum response time for MLD general queries is 10 seconds.
Views
MLD-snooping view
Predefined user roles
network-admin
Parameters
interval: Sets the maximum response time for MLD general queries, in the range of 1 to 3174 seconds.
Usage guidelines
To avoid mistakenly deleting IPv6 multicast group members, set the MLD general query interval to be
greater than the maximum response time for MLD general queries.
211