HP 5900 series Command Reference

[Sysname] igmp-snooping
[Sysname-vlan2] igmp-snooping general-query source-ip 10.1.1.1
Related c
• enable (IGMP-snooping view)
igmp-snooping group-limit
igmp-snooping group-limit to set the maximum number of multicast groups that a port can join.
Syntax
Predefine er roles
Paramete
cast groups that a port can join, in the range of 0 to
effect on all VLANs.
Usage gu
This command takes effect only on the multicast groups that a port joins dynamically.
Examples
Ten-GigabitEthernet 1/0/1 in VLAN 2 can join to
10.
face ten-gigabitethernet 1/0/1
[Sysname-Ten-GigabitEthernet1/0/1] igmp-snooping group-limit 10 vlan 2
igmp-
ing group-policy to configure a multicast group policy on a port to control the multicast
eceiver hosts attached to the port can join.
[Sysname-igmp-snooping] quit
[Sysname] vlan 2
[Sysname-vlan2] igmp-snooping enable
ommands
• igmp-snooping enable
Use
Use undo igmp-snooping group-limit to restore the default.
igmp-snooping group-limit limit [ vlan vlan-list ]
undo igmp-snooping group-limit [ vlan vlan-list ]
Default
The default setting is 4294967295.
Views
Layer 2 Ethernet interface view, Layer 2 aggregate interface view
d us
network-admin
rs
limit: Sets the maximum number of multi
4294967295.
vlan vlan-list: Specifies a space-separated list of up to 10 VLAN items. Each item specifies a VLAN by its
ID or a range of VLANs in the form of start-vlan-id to end-vlan-id. The value range for the VLAN ID is 1
to 4094. If you do not specify a VLAN, the command takes
idelines
# Set the maximum number of multicast groups that
<Sysname> system-view
[Sysname] inter
snooping group-policy
Use igmp-snoop
groups that the r
23

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)