HP 5900 series Command Reference

ipv6 p
t the hello interval on an interface.
llo to restore the default.
undo ipv6 pim timer hello
Default
val is 30 seconds.
Views
rface view
Predefine
or for the current interface in interface
er the configuration made in IPv6 PIM
Examples
llo interval to 40 seconds on VLAN-interface 100.
-interface 100
pim timer hello 40
ipv6 p
t the join/prune interval on an interface.
ne to restore the default.
undo ipv6 pim timer join-prune
Default
interval is 60 seconds.
Views
Interface view
im timer hello
Use ipv6 pim timer hello to se
Use undo ipv6 pim timer he
Syntax
ipv6 pim timer hello interval
The hello inter
Inte
d user roles
network-admin
Parameters
interval: Sets a hello interval in the range of 0 to 18000 seconds. If you set the value to 0 seconds, the
interface does not send hello messages.
lines Usage guide
You can set the hello interval for all interfaces in IPv6 PIM view
view. The configuration made in interface view takes priority ov
view.
# Set the he
<Sysname> system-view
[Sysname] interface vlan
[Sysname-Vlan-interface100] ipv6
Related commands
timer hello (IPv6 PIM view)
im timer join-prune
Use ipv6 pim timer join-prune to se
Use undo ipv6 pim timer join-pru
Syntax
ipv6 pim timer join-prune interval
The join/prune
335

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)