HP 5900 series Command Reference

120
Table 37 Command output
Field Descri
p
tion
Current state
Physical state of the register-tunnel interface. This field always displays
UP.
Line protocol state
Link state of the register-tunnel interface. This field always displays
DOWN.
Description Description of the register-tunnel interface. It is not configurable.
Bandwidth Expected bandwidth of the register-tunnel interface. It is not configurable.
Maximum Transmit Unit MTU of the register-tunnel interface. It is not configurable.
Internet protocol processing IP protocol processing capability. This field always displays disabled.
Physical
Physical type of the register-tunnel interface. This field always displays
Unknown.
Last 300 seconds input rate
Average incoming rate in the last 300 seconds. This field always displays
0.
Last 300 seconds output rate
Average outgoing rate in the last 300 seconds. This field always displays
0.
Input
Number of incoming packets, incoming bytes, and discarded packets.
This field always displays 0.
Output
Number of outgoing packets, outgoing bytes, and discarded packets.
This field always displays 0.
Brief information on interface(s)
under route mode
Brief information about Layer 3 interfaces.
Link: ADM - administratively down;
Stby - standby
Physical state of the interface:
• UP—The interface is physically up.
• DOWN—The interface is physically down.
• ADM—The interface has been administratively shut down. To recover
its physical state, use the undo shutdown command.
• Stby—The interface is a backup interface. To display information
about the primary interface, use the display interface-backup
command.
Protocol: (s) - spoofing
If the Protocol field contains "(s)", it means one of the following
conditions:
• The data link protocol state of the interface is up, but no link is present
on the interface.
• The link is created on demand.
Typically, null interfaces or loopback interfaces have this attribute.
Protocol
Protocol connection state of the interface. This field always displays
double hyphens (--).
Main IP IP address of the interface. This field always displays double hyphens (--).
Cause
Causes why the physical state of the interface is down. This field always
displays Not connected.

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)