HP 5900 series - 4 Connect to the printer; USB; Networking

source source-address: Specifies a multicast source by its IP address. If you do not specify a multicast
source, the command displays information about Layer 2 IP multicast groups for all multicast sources.
vlan vlan-id: Specifies a VLAN by its VLAN ID in the range of 1 to 4094. If you do not specify a VLAN,
the command displays information about Layer 2 IP multicast groups for all VLANs.
slot slot-number: Specifies an IRF member device by its member ID or a PEX by its virtual slot number. If
you do not specify this option, the command displays information about the Layer 2 IP multicast groups
on the master device.
Examples
# Display information about the Layer 2 IP multicast groups for VLAN 2.
<Sysname> display l2-multicast ip vlan 2
Total 1 entries.
VLAN 2: Total 1 IP entries.
(0.0.0.0, 224.1.1.1)
Attribute: static, success
Host slots (0 in total):
Host ports (1 in total):
XGE1/0/1 (S, SUC)
Table 7 Command output
Field Descri
p
tion
Total 1 entries Total number of Layer 2 IP multicast groups.
VLAN 2: Total 1 IP entries Total number of Layer 2 IP multicast groups in VLAN 2.
(0.0.0.0, 224.1.1.1) (S, G) entry, where 0.0.0.0 in the S position means any multicast sources.
Attribute
Entry attribute:
• dynamic—The entry is created by a dynamic protocol.
• static—The entry is created by a static protocol.
• pim—The entry is created by PIM.
• kernel—The entry is obtained from the kernel.
• success—Processing succeeds.
• fail—Processing fails.
Host slots (0 in total)
Member IDs of the member devices that have member ports and the total
number of the member devices (excluding the specified member device).
Host ports (1 in total) Member ports, and the total number of the member ports.
(S, SUC)
Port attribute:
• D—Dynamic port.
• S—Static port.
• P—PIM port.
• K—Port obtained from the kernel.
• R—Port learned from (*, *) entries.
entries.
• W—Port learned from (*, G)
ceeds.
• SUC—Processing suc
• F—Processing fails.
• BC—Broadcast port. The TRILL port floods the multicast traffic after the
topology changes.
9