HP 5900 series Command Reference

Use undo ipv6 multicast boundary to delete the specified IPv6 multicast forwarding boundary.
Syntax
up-address prefix-length | scope { scope-id | admin-local | global |
dress prefix-length| all | scope { scope-id | admin-local
| global | organization-local | site-local } }
Default
No IPv6 multicast forwarding boundary is configured.
Views
Predefine
ork-admin
Paramete
address in the range of FFxy::/16, where "x" and
.
ne, in the range of 3 to 15, which is identified by the
ID of 4.
cope ID of 8.
Specifies the scope zone as site-local, which has a scope ID of 5.
Usage gu
n address of an IPv6 multicast packet matches the set boundary
t groups must be in the same scope. The latest configuration of a scope overwrites the
subset of A. If B is configured after A, A still takes effect. If A is configured after
B will be removed.
Examples
-interface 100 to be the forwarding boundary of the IPv6 multicast groups in the range
ipv6 multicast boundary { ipv6-gro
organization-local | site-local } }
undo ipv6 multicast boundary { ipv6-group-ad
Interface view
d user roles
netw
rs
ipv6-group-address: Specifies an IPv6 multicast group
"y" represent any hexadecimal numbers from 0 to F.
prefix-length: Specifies an address prefix length in the range of 8 to 128
all: Specifies all IPv6 multicast boundaries configured on the interface.
scope-id: Specifies the ID of an admin-scope zo
scope field in the IPv6 multicast group address.
admin-local: Specifies the scope zone as admin-local, which has a scope
global: Specifies the scope zone as global, which has a scope ID of 14.
organization-local: Specifies the scope zone as organization-local, which has a s
site-local:
idelines
You do not need to enable IPv6 multicast routing before executing this command.
A multicast forwarding boundary sets the boundary condition for the IPv6 multicast groups in the
specified address range. If the destinatio
condition, the packet is not forwarded.
An interface can act as a forwarding boundary for multiple IPv6 multicast groups in different address
ranges. You can implement this by using this command on the interface for each multicast address range.
These multicas
previous one.
Assume that Set A and Set B are both IPv6 multicast forwarding boundary sets with different address
ranges, and that B is a
B,
# Configure VLAN
of FF03::/16.
<Sysname> system-view
[Sysname] interface vlan-interface 100
267

HP 5900 series Specifications

General

Ports	48x 10/100/1000BASE-T, 4x 10GE SFP+
Switching Capacity	1.28 Tbps
MAC Address Table Size	128K
Routing Protocols	RIP, OSPF, BGP, IS-IS
VLAN Support	4K VLANs
Dimensions	440 x 460 x 44 mm
Operating Temperature	0°C to 45°C
Operating Humidity	10% to 90% (noncondensing)