contain all outgoing interfaces. Whether the specified outgoing interface is contained in the IPv6 PIM
routing table depends on the following conditions:
• If you specify an excluded interface, the command displays IPv6 PIM routing entries that do not
contain the specified outgoing interface.
• If you specify an included interface, the command displays IPv6 PIM routing entries that contain the
specified outgoing interface.
• If you specify a matching interface, the command displays IPv6 PIM routing entries that contain only
the specified outgoing interface.
Examples
# Display IPv6 PIM routing entries on the public network.
<Sysname> display ipv6 pim routing-table
Total 0 (*, G) entry; 1 (S, G) entry
(2001::2, FFE3::101)
RP: FE80::A01:100:1
Protocol: pim-sm, Flag: SPT LOC ACT
UpTime: 02:54:43
Upstream interface: Vlan-interface1
Upstream neighbor: NULL
RPF prime neighbor: NULL
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface2
Protocol: pim-sm, UpTime: 02:54:43, Expires: 00:02:47
# Display the state machine information of IPv6 PIM routing entries on the public network.
<Sysname> display ipv6 pim routing-table fsm
Total 0 (*, G) entry; 1 (S, G) entry
Abbreviations for FSM states:
NI - no info, J - joined, NJ - not joined, P - pruned,
NP - not pruned, PP - prune pending, W - winner, L - loser,
F - forwarding, AP - ack pending, DR - designated router,
NDR - non-designated router, RCV - downstream receivers
(2001::2, FFE3::101)
RP: FE80::A01:100:1
Protocol: pim-sm, Flag: SPT LOC ACT
UpTime: 02:54:43
Upstream interface: Vlan-interface1
Upstream neighbor: NULL
RPF prime neighbor: NULL
Join/Prune FSM: [SPT: J] [RPT: NP]
Downstream interface(s) information:
Total number of downstreams: 1
1: Vlan-interface2
Protocol: pim-sm, UpTime: 02:54:43, Expires: 00:02:47
DR state: [DR]
315