Korg NAUTILUS Series

EXi: STR-1 Plucked String
232
4–9: Mixer
The Mixer page controls the volume levels and filter routing
for the main String output, as well as the direct outputs
(bypassing the string) of the PCM oscillator and Noise
Generator. For instance, you can:
• Control the volume levels for the String, the PCM
Oscillator, and the Noise Generator.
• Modulate these volume levels via AMS.
•When the Filter Routing is set to either Serial or
Parallel, you can route each of the five elements through
Filter A, Filter B, or a combination of the two–and then
modulate that routing via AMS. For instance, you can
create a layer by setting the Filter Routing to Parallel,
and then sending the PCM Oscillator to Filter A, and the
String to Filter B.
4–9a: String
Level [0…100]
This controls the volume level for the String.
AMS [List of AMS Sources]
This selects an AMS source to control the String Level. For
a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [-100…+100]
This controls the depth and direction of the String Level
AMS modulation.
Balance [0…100]
This controls the filter routing for the String. It applies only
when the Filter Routing is set to either Serial or Parallel;
otherwise, it is grayed out.
0 is the default, and means that the String goes into Filter A.
If the Filter Routing is set to Serial, it will also pass through
Filter B.
99 means that the String goes into Filter B.
In between, the String will go to a combination of both
filters. By modulating the Balance via AMS, you can
crossfade between routing through Filter A and Filter B. For
more information, see “Interaction between the filters and
the mixer,” on page 234.
AMS [List of AMS Sources]
This selects an AMS source to control the String Balance.
For a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [-100…+100]
This controls the depth and direction of the String Balance
AMS modulation.
Phase Invert [Off, On]
This inverts the phase of the String.
4–9b: PCM Oscillator
This controls the volume level and balance for the PCM
Oscillator. It has the same parameters as described under “4–
9a: String,” above.
4–9c: Noise
The Noise Generator has the same mixer parameters as
described under “4–9a: String,” above.
4–9d: Pickup 1
Pickup 1 has the same mixer parameters as described under
“4–9a: String,” above.
Try inverting the phase for one of the two pickups; this can
produce an interesting effect.
4–9PMC
4–9a
4–9b
4–9c
4–9d
4–9e