SAMPLING mode
594
SAMPLING >EQ
In this page you can edit a mid-sweepable three-band EQ
that is applied to the output of the multisample.
4–1: EQ
Here you can edit the mid-sweepable three-band EQ that is
applied to the output of the multisample.
4–1a: 3 Band Parametric EQ
(All OSCs)
Bypass [Off, On]
When Bypass is checked, all of the EQ will be disabled,
including the Input Trim.
Bypass can be convenient for comparing the results of the
EQ with the original signal.
Input Trim [00…99]
This adjusts the level of the signal going into the EQ. A
setting of 50 corresponds to –6 dB, and a setting of 25
corresponds to –12 dB.
High settings of the Low, Mid, and High Gain controls can
cause substantial increases in the overall level. You can
compensate for this by turning down the input trim.
(Freq Response Graphic)
Low Gain [–18.0…+00.0…+18.0dB]
This controls the gain of the 80Hz Low Shelf EQ, in
increments of 0.5dB.
Mid Frequency
[100…500 (10Hz step) … 1.0k (20Hz step) … 2.0K
(50Hz step) … 10.0k (100Hz step)]
This sets the center frequency for the Mid sweep EQ.
Mid Gain [–18.0…+00.0…+18.0dB]
This controls the gain of the Mid Sweep EQ, in increments
of 0.5dB.
High Gain [–18.0…+00.0…+18.0dB]
This controls the gain of the 10kHz High Shelf EQ, in
increments of 0.5dB.
v
4–1: Page Menu Commands
• Delete Sample →p.606
• Copy Sample →p.606
• Rename Sample →p.606
• Move Sample →p.607
• Sample Mono To Stereo (Change Sample Type) →p.607
• Delete MS (Delete Multisample) →p.608
• Copy MS (Copy Multisample) →p.608
• Rename MS (Rename Multisample) →p.608
• Move MS (Move Multisample) →p.608
• Convert MS (Multisample) To Program →p.609
• MS Mono To Stereo/MS Stereo To Mono
(Change Multisample Type) →p.610
• Optimize RAM →p.114
• Select Directory/File for Sample To Disk →p.115
• Auto Sampling Setup →p.611
• PAGE →p.126
•MODE →p.126
To Next Page
Loading...
Need help?
General
