Korg NAUTILUS Series

COMBINATION: Page Menu Commands Write Combination
433
COMBINATION: Page Menu Commands
Compare →p.112
Write Combination →p.433
Exclusive Solo →p.113
Copy From Program →p.433
Add To Set List →p.113
Load required samples →p.114
Edit Program →p.434
Initialize Combination →p.435
Optimize RAM →p.114
Select Sample No. →p.115
Select Directory/File for Sample To Disk →p.115
Auto Sampling Setup →p.116
Copy Tone Adjust →p.436
Reset Tone Adjust →p.436
Show EQ Graphic →p.436
Copy X-Y Envelope →p.119
Detune BPM Adjust →p.437
Copy External Scene →p.121
Copy Scene →p.121
Swap Scene →p.122
Initialize Scene →p.122
Copy Insert Effect →p.122
Swap Insert Effect →p.122
Insert IFX Slot →p.122
Clean Up IFX Routings →p.124
Drum Kit IFX Patch →p.437
Copy MFX/TFX →p.125
Swap MFX/TFX →p.125
Write FX Preset →p.125
PAGE →p.126
MODE →p.126
Write Combination
This command writes an edited Combination into the
NAUTILUS internal memory. It is available on every page
in COMBINATION mode.
This lets you:
• Save your edits
• Rename the Combination
• Assign the Combination to a Category
• Mark the Combination as a Favorite
• Copy the Combination to a different Bank and number
Be sure to Write any Combination that you wish to save. An
edited Combination cannot be recovered if you do not write
it before turning off the power or selecting another
Combination.
Do not turn off the power for at least 10 seconds after
using the Write Combination command. This allows the
system time to complete the process, which includes
saving a backup of the data to the internal drive.
For more information, please see “Write Program” on
page 112.
If you use “Category” or ‘Sub Category” to specify a
category for the combination you are writing, you will be
able to select that combination by its category or sub
category in COMBINATION > Home.
The names of the combination categories can be edited in
“Combi Category” (GLOBAL 3–2).
Exclusive Solo
This command is available on every page in
COMBINATION mode. When Exclusive Solo is On, only
one Timbre is soloed at a time; when it is Off, multiple
Timbres can be soloed together.
For more information, please see “Exclusive Solo” on
page 113.
Copy From Program
This command is available on every page in
COMBINATION mode. It copies Effects and/or ARP
settings from a selected Program to the current Combination.
This lets the Program sound the same as it did in
PROGRAM mode.
1. Select “Copy From Program” to open the dialog box.
2. Use “Program” to select the copy-source program.
3. Select the IFX-All, IFX-All used, MFXs, and TFXs
options to specify which, if any, of the Program’s
effects settings to copy.
IFX-All: The settings of all insert effect settings (the
contents of the Insert FX page and the IFX1–12 effect
parameters) of the copy-source program will be copied.
IFX-All used: Only the insert effects used by the copy-
source program will be copied. The copied settings will
be packed into vacant slots (i.e., slots with 000: No
Effect, unless such slots are located inside the chain).