Chorus, Flanger, and Phaser 046: Ensemble
805
046: Ensemble
This Ensemble effect has three chorus blocks that use LFO
to create subtle shimmering, and gives three dimensional
depth and spread to the sound, because the signal is output
from the left, right, and center.
ENSEMBLE
Depth [0…100]
Sets the depth of the LFO modulation.
Source [Off…Tempo]
Selects the modulation source for the LFO depth.
Amount [+/–100]
Sets the modulation amount of the LFO modulation depth.
LFO
Speed [1…100]
Sets the LFO speed.
Source [Off…Tempo]
Selects a modulation source for LFO speed.
Amount [+/–100]
Sets the modulation amount of LFO speed.
Shimmer [0…100]
This parameter sets the amount of shimmering of the LFO
waveform. Increasing this value adds more shimmering,
making the chorus effect more complex and richer.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
047: Polysix Ensemble
This models the ensemble effect built into the classic Korg
PolySix programmable polyphonic synthesizer.
POLYSIX ENSEMBLE
Depth [0…100]
Sets the depth of the effect.
Source [Off…Tempo]
Selects the modulation source that will control the effect
depth.
Amount [+/–100]
Sets the amount by which the effect depth will be modulated.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
LFO
Shimmer
+
Ensemble
Time
Level
Ensemble LFO
Shimmer
+
Polysix
Ensemble
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
To Next Page
Loading...
Need help?
General
