Korg NAUTILUS Series

COMBINATION mode
394
0–9: Tone Adjust
0–9a: Tone Adjust
Tone Adjust provides two important features
simultaneously:
• It lets you use all of the sliders, and switches to control
Program parameters - like the knobs on an analog synth,
or the drawbars on an organ.
• It lets you modify Programs for use within a specific
Combi, including everything from subtle tweaks (like
changing LFO speeds) to dramatic changes (such as
selecting a different Multisample). Any changes that you
make are stored with the Combi, and do not alter the
original Program.
Each of the sixteen Timbres has its own set of tone adjust
parameters, but only one Timbre is shown at a time.
For more information, see:
• “Tone Adjust and MIDI SysEx” on page 30
• “Interaction between Tone Adjust and MIDI CCs” on
page 30
• “Absolute, Relative, and Meta parameters” on page 30
Saving Tone Adjust Edits
In PROGRAM mode, when you make edits via Tone Adjust
and then save the results, the Program data is changed–just
as if you’d edited the internal parameters directly. For more
information, see “Saving Tone Adjust Edits” on page 29.
In COMBINATION mode, however, all Tone Adjust edits
are stored within the Combi; the Program itself is not
changed. This lets you alter the way that a Program sounds
in one specific Combi without affecting the way that it
sounds in PROGRAM mode, or in any other Combis or
Songs.
Switches 1–16 button
Switches to the Switch page of Tone Adjust.
Sliders 1–8, 9–17 buttons
Switches to the Slider page of Tone Adjust.
Timbre select
Timbre [1…16]
This selects the Timbre whose Tone Adjust parameters
appear on the screen. You can switch back and forth between
the different Timbres as much as you like, without losing
your edits.
Auto Load Prog [Off, On]
When you first load a Program into a Timbre, this parameter
determines whether or not the Program’s Tone Adjust
settings will be loaded as well.
These settings include the parameters assigned to each slider,
and switch, along with the on/off state of any Switches
assigned to Absolute parameters.
Note that any edits you’ve made using Tone Adjust in
PROGRAM mode will already have been stored into the
Program’s parameters. This means that the Program will still
sound the same, whether or not you load the Tone Adjust
settings.
Once the Program has been loaded, you can change any or
all of the Tone Adjust settings as desired, including both
assignments and values. All such edits are stored in the
Combi, without affecting the original Program.
If Auto Load PRG is On, Tone Adjust settings will be
automatically loaded along with the Program.
If Auto Load PRG is Off, then the relationship between the
types of the old and new Programs will determine what
happens, as shown in the table below:
0–9PMC
0–9a
0–9b