Korg NAUTILUS Series - PROGRAM > CX-3: Amp, V;C, Rotary Speaker; 7-1: Amp;V;C

PROGRAM > CX-3: Amp, V/C, Rotary Speaker 7–1: Amp/V/C
197
PROGRAM > CX-3: Amp, V/C, Rotary Speaker
7–1: Amp/V/C
7–1a: Amp
Amp Type [Type 1, Type 2, Pre Amp]
This selects one of two amp models, or a direct line-out from
the organ’s preamp.
Type 1 is a standard powered amp for organ, producing a
warm, fat tone.
Type 2 yields a less colored tone, with more high
frequencies than Type 1.
PreAmp is the sound of a direct line-out from the organ.
Important: Since Pre Amp models a direct line-out, it
disables the Rotary Speaker entirely. To use the Rotary
speaker, set Amp Type to Type 1 or Type 2 instead.
Amp Gain [00…99]
This adjusts the gain when Amp Type is set to Type 1 or
Type 2. It does not apply if the Amp Type is set to PreAmp.
Expression also adjusts the drive into the Amp section. With
higher Amp Gain settings, you’ll get more overdrive and
distortion as you increase the Expression amount. For more
information, see “4–2b: Expression,” on page 188.
AMS [List of AMS Sources]
This selects an AMS source to modulate the Amp Gain. For
a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [-99…+99]
This controls the depth and direction of the AMS modulation
of Amp Gain.
7–1b: EQ
Treble [-10…+10]
This adjusts the high frequency range of the amp, as selected
by Amp Type.
Mid [-10…+10]
This adjusts the mid-frequency range of the amp, as selected
by Amp Type.
Bass [-10…+10]
This adjusts the low frequency range of the amp, as selected
by Amp Type.
7–1c: Vibrato/Chorus
Vibrato/Chorus is a traditional organ effect, similar to but
not the same as other chorus effects. It adds varying degrees
of LFO-driven flutter and richness to the timbre, and
combines nicely with the rotary speaker.
In addition to the six traditional presets, the CX-3 allows you
to create your own custom settings, which can then be
modulated via AMS.
There is a single Vibrato/Chorus effect, and each set of
drawbars can either be routed through the effect or go
straight on to the rotary speaker and outputs.
Upper Drawbars V/C [Off, On]
This routes the upper drawbars through the Vibrato/Chorus.
AMS [List of AMS Sources]
This selects an AMS source to turn Vibrato/Chorus on or off
for the Upper Drawbars.
7–1PMC
7–1a
7–1f
7–1c
7–1e
7–1b
7–1d