Korg NAUTILUS Series

Mono/Mono Parallel 141: P4EQ // P4EQ
879
Times [x1…x32]
Sets the number of notes to specify the delay time for Tap1.
See “Times” on page 825.
Tap2 Base Note [ …  ]
Selects the type of notes to specify the delay time for Tap2.
See “Base Note” on page 825.
Times [x1…x32]
Sets the number of notes to specify the delay time for Tap2.
See “Times” on page 825.
Tap1 Level [0…100]
Sets the Tap1 output level.
Feedback [+/–100]
Sets the Tap2 feedback amount.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation. See “High
Damp [%]” on page 833.
OUTPUT
Pan [L000…C064…R127]
Sets the stereo image.
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the balance between the effect and the dry input.
Source [Off…Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
141: P4EQ // P4EQ
This effect connects two four-band EQ units in parallel. The
pan and effect balance can be adjusted independently for
each.
For detailed information on the effects parameters, see “4
band EQ” on page 876.
142: P4EQ // Comp
This effect connects a four-band EQ and a compressor in
parallel. The pan and effect balance can be adjusted
independently for each.
For detailed information on the effects parameters, see “4
band EQ” on page 876 and “Compressor” on page 876.
Left
Right
Stereo In - Stereo Out
Wet / Dry Pan
Wet / Dry Pan
Trim
Trim
Parametric 4Band EQ
Parametric 4Band EQ
Parametric 4Band EQ
Parametric 4Band EQ
Envelope - Control
Left
Right
Wet / Dry Pan
Wet / Dry Pan
Stereo In - Stereo Out
Trim
Trim LEQ HEQ
Output Level
Compressor
Parametric 4Band EQ
Compressor
Parametric 4Band EQ