Korg NAUTILUS Series

Chorus, Flanger, and Phaser 054: Bi Phaser
811
054: Bi Phaser
This effect provides two independent phasers that can be
connected in series or in parallel.
PHASER1
Manual [0…100]
Sets the frequency of phaser 1.
LFO1 Depth [0…100]
Sets the LFO modulation depth of phaser 1.
Source [Off…Tempo]
Selects a source to control LFO modulation depth of both
phasers.
Amount [+/–100]
Sets the amount by which the phaser 1 LFO modulation
depth will be controlled.
Resonance [0…100]
This controls the intensity of Phaser 1. For more
information, see “Resonance” on page 808.
PHASER2
Manual [0…100]
Sets the frequency of phaser 2.
LFO2 Depth [0…100]
Sets the LFO modulation depth of phaser 2.
Amount [+/–100]
Sets the amount by which the phaser 2 LFO modulation
depth will be controlled.
Resonance [0…100]
This controls the intensity of Phaser 1. For more
information, see “Resonance” on page 808.
LFO1/2
These are the parameters for the two LFOs, which are
identical to those in the Bi Chorus effect. For more
information, see “LFO1/2” on page 803.
MODE
Routing [Dual, Serial]
Selects whether the phasers are connected in parallel or in
series. If Routing is set to Serial, the Phaser 1 Output
Level and Phaser 2 Output Level settings are ignored.
Output Mode [Mono, Stereo]
Selects whether phaser 1 and 2 will be routed separately to
the left and right channels, or summed to mono.
Phaser1 Output Level [0…100]
Sets the output level for phaser 1. This applies only if
Routing is set to Dual.
Phaser2 Output Level [0…100]
Sets the output level for phaser 2. This applies only if
Routing is set to Dual.
OUTPUT
Wet/Dry [–Wet… –1:99, Dry, 1: 99…Wet]
Sets the balance between the “wet” processed sound and the
dry input. Negative values invert the phase of the wet signal.
This interacts with Resonance; for more information, see
“Resonance” on page 808.
Source [Off…Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
Wet: Mono In - Stereo Out / Dry: Stereo In -Stereo Out
Left
Right
Wet / Dry
Wet / Dry
Phaser
Phaser
Phase Lock
+
Mode
Serial
Dual
Resonance
Output Level1
Output Level2
Resonance
+
LFO2
LFO1
Output Mode
Routing / Output Mode / Output Level 1/2
Routing: Dual
Output Mode: Stereo
Routing: SerialRouting: Dual
Output Mode: Mono
Output Level1/2Output Level1/2