Korg NAUTILUS Series

SEQUENCER > IFX 8–3: Audio Routing1
511
8–3: Audio Routing1
Here you can specify the buses for the outputs of audio
tracks 1–16. You can also adjust the send amounts to the
master effects.
Audio tracks 1–16 can be processed by the insert effects,
master effects, and total effects, and routed to the desired
buses, in the same way as for MIDI tracks 1–16.
8–3a: Audio Routing1
Track 01 (Track Number)
STEREO
This is shown if Stereo Pair is on.
Bus Select (IFX/Indiv. Out Assign) [L/R, IFX1…12,
1…4, 1/2…3/4, Off]
This specifies the bus for the audio track. The current
settings can also be viewed in the Routing Map. This
parameter can also be edited from the IFX– Audio Routing 2
page.
For more information, please see “Bus Select (IFX/Indiv.Out
Assign)” on page 507.
Send1 (MFX1) [000…127]
Send2 (MFX2) [000…127]
For each audio track, these parameters set the send level to
master effects 1 and 2. These settings are valid when Bus
Select (IFX/Indiv. Out Assign) is set to L/R or Off. When
IFX 1–12 are selected, the send levels to master effects 1 and
2 are set by the Send1 and Send2 parameters of the Insert
FX page, after the sound has passed through IFX1–12.
If Bus Select is set to 1…4 or 1/2…3/4, these settings are
ignored.
The Send 1 and 2 setting you specify here are used when
playing-back or recording from the beginning of the song. If
you modify these settings during recording, your changes
will be recorded as automation event; the send amounts will
change accordingly during playback. You can also modify
these settings during playback. However if Send 1 and 2 data
has been recorded, the settings will change according to the
recorded data.
Track 02…16 (Track Number)
Here you can specify the output bus and master effect send
amount for each audio track 2 through 16. These are the
same as for track 1. See “Track 01”:.
v 8–3: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Copy Insert Effect →p.122
• Swap Insert Effect →p.122
• Stereo Pair →p.525
• Put Effect Setting to Track →p.554
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
•PAGE →p.126
•MODE →p.126
8–1a
8–3PMC
8–3a
1–1a
1–1b