COMBINATION mode
412
2–6: EXi Audio Input
These parameters let you route audio into EXi instruments
which support audio input, including the STR-1, MS-20EX,
and MOD-7. You can use this to create feedback loops, or to
process live or recorded audio through the EXi’s synthesis
engine.
EXi which do not support audio input will ignore these
settings. The AL-1 supports audio input, but uses its own
dedicated routing which is not affected by these parameters.
For more information on using audio inputs with EXi, see:
• AL-1: “4–3c: Sub OSC/Audio Input” on page 149
• STR-1: “4–8c: Feedback” on page 231
• MS-20EX: “6–1k: EXTERNAL SIGNAL PROCESSOR
(ESP)” on page 273
• MOD-7: “5–1f: EXi Audio Input” on page 319
2–6a: EXi 1
Input Source [PRG, Off, Audio Input 1/2,
USB 1/2, L/R Output, Indiv. Output 1/2…3/4,
REC 1/2…3/4, FX Control 1, 2,
IFX 1…12, MFX 1, 2, TFX 1, 2]
This selects the input source for EXi1. You can use this to
create a feedback loop, if desired.
PRG uses the setting stored in the Program. For more
information, see “4–2: EXi Audio Input” on page 134.
Off disables the input.
Audio Input 1/2, and USB 1/2 use the live audio from the
selected input.
L/R Output and Indiv. Output 1/2…3/4 use the audio as it
is heard from the selected output (like connecting a cable
from the output back to the input).
REC 1/2…3/4 and FX Control 1, 2 use the audio from the
selected bus.
IFX 1…12, MFX 1, 2, and TFX 1, 2 use the output of the
selected effect.
Channel Select [Stereo/L+R, Left, Right]
Stereo/L+R: This selection routes a stereo signal to EXi
with stereo inputs, and an L+R summation to EXi with mono
inputs.
Left, Right: This uses only a mono signal from the selected
channel.
2–6b: EXi 2
EXi2 has the same controls as EXi1, above.
v
2–6: Page Menu Commands
• Compare →p.112
• Write Combination →p.433
• Exclusive Solo →p.113
• Copy From Program →p.433
• PAGE →p.126
•MODE →p.126
2–6PMC
2–6a
2–6b
1–1a
1–1b
To Next Page
Loading...
Need help?
General
