Outputs Main Outputs
757
Outputs
Main Outputs
The main L/MONO and R outputs of the NAUTILUS are
output from the AUDIO OUTPUT (MAIN) L/MONO and R
jacks, and the headphone jack.
Individual Outputs
The NAUTILUS is equipped with four individual audio
outputs, which can be used as individual mono outputs,
stereo pairs, or any combination of the two. Almost any
signal source can be routed to these outputs, including:
• Each note in a Drum Kit
• Insert Effect outputs
• Each Program in a Combination or Song
• Audio tracks
• Audio inputs
You can use these to isolate or group together sounds for
recording, or for complex live performance setups.
If the signal is going through one or more insert effects, the
output is set at the last IFX in the chain, via the Bus Select
parameter on the IFX– Insert Effects page.
If a Program, Timbre, or Track is not going through any
insert effects, the output is set using the Bus Select
parameters on the IFX– Routing page.
To assign audio inputs directly to outputs, use Bus Select
parameters in the Sampling– Audio Input page.
In GLOBAL mode, the Audio page L/R Bus Indiv. Assign
setting lets you mirror the MAIN stereo L/R output on any
pair of individual outputs. You can use this to create a
private monitoring setup in live and studio environments.
For more information, see “L/R Bus Indiv. Assign” on
page 638 of the Parameter Guide.
Note: You can’t use the VOLUME knob to adjust the
volume of the individual outputs.
To Next Page
Loading...
Need help?
General
