Korg NAUTILUS Series

COMBINATION > MIDI Filter/Zones 3–1: MIDI Filter1
413
COMBINATION > MIDI Filter/Zones
3–1: MIDI Filter1
These settings allow you to apply filters to the MIDI data
that will be transmitted and received by each timbre 1–16.
For example even if two timbres are being played by the
same MIDI channel, you can make settings so that the
damper pedal will apply to one but not the other.
On (checked): Transmission and reception of MIDI data is
enabled.
When Status (0–1b, 2–1a) is INT, operation of the built-in
controllers or incoming MIDI data will apply the effect of
the checked item to the program of the corresponding
timbre. (The effect dynamic modulation function is not
affected by this setting.)
In the case of EXT or EX2, operating a controller on the
NAUTILUS will transmit MIDI data on the channel of that
timbre. MIDI transmission/reception settings for the entire
NAUTILUS can be made in “MIDI Filter” (GLOBAL 1–
1b).
The MIDI Filter pages 2 and 3 contain MIDI filters for
assignable controllers (whose function can be set by the
user), and if these are assigned to MIDI control changes, the
filter settings will affect those control changes. In this case,
if the same control change as Knob 1, 2, 3, or 4 has been
assigned in MIDI Filter pages 1 and 2, the settings in MIDI
Filter pages 1 and 2 will take priority. Also, if the same
control change is assigned to two or more controllers in the
MIDI Filter pages 2 and 3, checking any one of them will
enable that control change.
Off (unchecked): Transmission and reception of MIDI data
is disabled.
Note: MIDI CC# = MIDI control change message numbers.
3–1a: MIDI Filter1
Timbre 01
Enable Program Change [Off, On]
Specifies whether or not MIDI program change messages
will be transmitted and received.
Enable After Touch [Off, On]
Specifies whether or not MIDI after touch messages will be
received.
Enable Damper [Off, On]
Specifies whether or not MIDI CC#64 hold (damper pedal)
messages will be transmitted and received.
Enable Portamento SW [Off, On]
Specifies whether or not MIDI CC#65 portamento on/off
messages will be transmitted and received.
Enable JS X as AMS [Off, On]
Specifies whether or not MIDI pitch bend messages (the X
axis of the NAUTILUS’s joystick) will be received to
control the AMS effect assigned to JS X. (This is not a filter
for MIDI pitch bend message reception.) For more
information, please see “Alternate Modulation Sources
(AMS)” on page 899.
Enable JS+Y [Off, On]
Specifies whether MIDI CC#01 (the +Y axis of the
NAUTILUS’s joystick setting) will be transmitted and
received.
3–1PMC
3–1a
1–1a
1–1b