EXi MOD-7: Page Menu Commands Copy VPM Oscillator
347
EXi MOD-7: Page Menu Commands
Compare →p.112
Write Program →p.112
Exclusive Solo →p.113
Remap MS/Sample Banks →p.125
Copy Envelope →p.182
Swap Envelope →p.182
Copy Step Sequencer →p.140
Copy LFO →p.182
Swap LFO →p.182
Delete All Connections →p.282
Copy VPM Oscillator →p.347
Swap VPM Oscillators →p.347
PAGE →p.126
MODE →p.126
Copy VPM Oscillator
This command copies all the parameters of one VPM
Oscillator to another VPM Oscillator. A dialog box allows
you to select the source and destination Oscillators, within
the current Program.
Swap VPM Oscillators
This command swaps all of the parameters between two
VPM Oscillators, like copying each to the other in a single
step. Note that it does not automatically copy any Patch
Panel connections; you’ll need to do that manually, if
necessary.
For instance, let’s say that you’ve created a custom
algorithm bit by bit, and you end up with two chains of
Modulators and Carriers:
VPM Osc 1–>VPM Osc 2–>VPM Osc 6
VPM Osc 4–>VPM Osc 5–>VPM Osc 3
To make the algorithm easier to understand, you might want
to do the following:
1. Use the Swap VPM Oscillator command to swap the
parameters of VPM Osc 3 and VPM Osc 6.
2. Manually correct the Patch Panel connections to VPM
Osc 3 and 6, as necessary.
To Next Page
Loading...
Need help?
General
