Korg NAUTILUS Series

834
R Delay Time [msec] [0…5460]
Sets the delay time of the Right Delay.
Level [0…50]
Sets the output level of the Right Delay.
Feedback (C Delay) [+/–100]
Sets the feedback amount of the Center Delay.
Source [Off…Tempo]
Selects the modulation source for the Center Delay
feedback.
Amount [+/–100]
Sets the modulation amount of the Center Delay feedback.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation for the
feedback path.
Low Damp [%] [0…100]
This controls the low-frequency damping in the feedback
loop. See “Low Damp [%]” on page 833.
Spread [0…50]
This controls the stereo width of the effect. The stereo image
is widest with a value of 50, and narrows to mono with a
value of 0.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
079: Stereo/Cross Delay
This is a stereo delay with adjustable feedback routing, high
and low damping, modulatable feedback and input level, and
up to 1,360msec of delay time.
INPUT
Input Level Dmod [%] [+/–100]
Sets the modulation amount of the input level. p.823.
Source [Off…Tempo]
Selects the modulation source for the input level. p.823.
DELAY
Stereo/Cross [Stereo, Cross]
Switches between stereo delay and cross-feedback delay.
L Delay Time [msec] [0.0…1360.0]
Sets the delay time for the left channel.
R Delay Time [msec] [0.0…1360.0]
Sets the delay time for the right channel.
L Feedback [+/–100]
Sets the feedback amount for the left channel.
R Feedback [+/–100]
Sets the feedback amount for the right channel.
Source [Off…Tempo]
Selects the modulation source of feedback amount.
L Amount [+/–100]
Sets the modulation amount of the left channel feedback.
R Amount [+/–100]
Sets the modulation amount of the right channel feedback.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation for the
feedback path.
Low Damp [%] [0…100]
This controls the low-frequency damping in the feedback
loop. See “Low Damp [%]” on page 833.
Spread [–50…+50]
This controls the stereo width of the effect. The stereo image
is widest with a value of 50, and narrows to mono with a
value of 0.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Delay
Delay
Stereo/Cross
Left
Right
Feedback
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
Input Level D-mod
Input Level D-mod
High Damp Low Damp
High Damp
Low Damp
Spread
Stereo/Cross