EXi: SGX-2 Premium Piano
356
SGX-2: Tone adjust
SGX-2 Tone Adjust Default Settings
Common Tone Adjust parameters
The SGX-2 supports the following Common Tone Adjust
parameters:
Off. This means that the Tone Adjust control has no effect.
Filter Cutoff. (–99…+99, CC#74, Relative)
This scales the Lid Position.
Amp Velocity Intensity. (–99…+99, Relative)
This scales the effect of velocity on volume.
–99 removes the velocity modulation entirely. +99 means
maximum modulation in the same direction, positive or
negative, as the original Program.
Filter/Amp EG Release Time.
(–99…+99, CC#72, Relative)
This scales the Release Time.
Common LFO Speed. (–99…+99, Relative)
This scales the EXi Program’s Common LFO Frequency.
When the LFO is in MIDI/Tempo mode, this adjusts the
Base Note.
Common Step Sequencer Attack Smoothing. (00…99,
Absolute)
This Absolute parameter sets amount of attack smoothing
for the Common Step Sequencer. For more information,
please see “Smoothing” on page 137.
Common Step Sequencer Decay Smoothing. (00…99,
Absolute)
This Absolute parameter sets amount of decay smoothing
Resonance
Level
Velocity
Intensity
Release
Time
Note Release
Level
Mechanical
Noise Level
Damper
Noise Level
Velocity
Bias
Lid Position
Buttons:
5: Note Release Enable
6: Mechanical Noise Enable
7: Damper Noise Enable
Buttons:
1: Stereo Perspective
2: Resonance Enable
Button:
9: String Resonance
Enable
Slider:
1: String Resonance
Depth
To Next Page
Loading...
Need help?
General
