MOD-7: Tone Adjust Common Tone Adjust parameters
345
MOD-7: Tone Adjust
MOD-7 Tone Adjust Default Settings
Tone Adjust provides an elegant physical interface to the
MOD-7’s parameters. Most of the factory sounds use the
default layout, as shown above. You can also customize the
layout for individual sounds, if desired.
For more information about Tone Adjust, please see “0–9a:
Tone Adjust,” on page 29.
Common Tone Adjust parameters
Except as noted below, the Common Tone Adjust parameters
behave as described under “Common Tone Adjust
Parameters,” on page 31.
Filter/Amp EG Attack Time.
(–99…+99, CC#73)
This scales the attack time of EG8 and the Amp EG. It
interacts with CC# 73.
Filter/Amp EG Decay Time.
(–99…+99, CC#75)
This scales the decay time of EG8 and the Amp EG. It
interacts with CC# 75.
Filter/Amp EG Sustain Level.
(–99…+99, CC#70)
This scales the sustain levels of EG8 and the Amp EG. It
interacts with CC# 70.
Filter/Amp EG Release Time.
(–99…+99, CC#72)
This scales the release time of EG8 and the Amp EG. It
interacts with CC# 72.
Filter EG Attack Time, Decay Time, Sustain Level, and
Release Time apply to EG8.
Pitch EG Attack Time, Decay Time, Sustain Level, and
Release Time are not supported by the MOD-7.
VPM Osc 1–6 Ratio
Filter A
Cuto
Filter B
Cuto
Macro
Brightness
Macro
Timbre
Macro
Feedback
Button 7, 8:
LFO 1 & 2 Stop
Buttons 1–6:
VPM Osc 1–6
On/O
Button 9, 10:
PCM On &
Reverse
VPM Osc 1–6 Output Level
To Next Page
Loading...
Need help?
General
