Korg NAUTILUS Series

EXi PROGRAM > Basic/X-Y/Controllers 4–5: X-Y Control
135
Channel Select [Stereo/L+R, Left, Right]
Stereo/L+R: This selection routes a stereo signal to EXi
with stereo inputs, and an L+R summation to EXi with mono
inputs.
Left, Right: This uses only a mono signal from the selected
channel.
4–2b: EXi 2
EXi 2 has the same controls as EXi 1, above.
v 4–2: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy EXi Oscillator →p.140
•PAGE →p.126
•MODE →p.126
4–5: X-Y Control
Vector Synthesis lets you control Program and Effects
parameters, by using the programmable X-Y Envelope, or
by the combination of the two.
This is the same as with HD-1 programs. For more
information, see “1–5: X-Y Control” on page 41.
v 4–5: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy EXi Oscillator →p.140
•PAGE →p.126
•MODE →p.126
4–6: X-Y Envelope
The X-Y Envelope works to control the X-Y position. It’s
also special because it’s the only programmable modulation
source which lets you modulate both Program and Effects
parameters.
The X-Y Envelope is different from the other envelopes in
several ways:
• Each point has two “levels” - one for the X axis, and one
for the Y axis.
• The envelope times can be based on seconds and
milliseconds, or synced to tempo.
• Each point has a hold time, as well as a transition time to
the next point.
• The envelope can loop between two points, for either a
specified number of repeats, or as long as you hold the
note.
This is the same as with HD-1 programs. For more
information, see “1–6: X-Y Envelope” on page 45.
v 4–6: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy EXi Oscillator →p.140
• Copy X-Y Envelope →p.119
•PAGE →p.126
•MODE →p.126
4–8: Controllers
This page lets you set up the functionality of SW1/2 and RT
Control Knobs 1–6. This is set for each program.
This is the same as with HD-1 programs. For more
information, see “1–8: Controllers” on page 48.
v 4–8: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy EXi Oscillator →p.140
•PAGE →p.126
•MODE →p.126