Korg NAUTILUS Series

Chorus, Flanger, and Phaser 052: Stereo Random Phaser
809
OUTPUT
Wet/Dry [–Wet… –1:99, Dry, 1: 99…Wet]
Sets the balance between the “wet” processed sound and the
dry input. Negative values invert the phase of the wet signal.
This interacts with Resonance; for more information, see
“Resonance” on page 808.
Source [Off…Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
052: Stereo Random Phaser
This is a stereo phaser. The effect uses a step-shape
waveform and random LFO for modulation, creating a
unique phasing effect.
PHASER
Manual [0…100]
Sets the frequency to which the effect is applied.
Depth [0…100]
Sets the depth of LFO modulation.
Resonance [+/–100]
This controls the intensity of the phaser. For more
information, see “Resonance” on page 808.
High Damp [%] [0…100]
This sets the amount of high-frequency attenuation in the
phaser’s feedback loop. Increasing the value will reduce
high-frequency harmonics.
LFO
Waveform [Step-Tri, Step-Sin, Random]
Selects the LFO Waveform. For more information, see
“Waveform” on page 781.
Phase [degrees] [–180…+180]
Sets the LFO phase difference between the left and right. See
“Phase [degrees]” on page 781.
Frequency [Hz] [0.02…20.00]
Step Frequency [Hz] [0.05…50.00]
Source [Off…Tempo]
Amount [–20.00…+20.00]
Step Amount [–50.00…+50.00]
These parameters control the speed of the LFO when
MIDI/Tempo Sync is Off. For more information, see
“Frequency” on page 781.
MIDI/Tempo Sync [Check-box]
BPM [MIDI, 40.00…300.00]
Base Note [ …  ]
Times [x1…x32]
Step Note [ …  ]
Times [x1…x32]
These parameters control the speed of the LFO when
MIDI/Tempo Sync is On. For more information, see
“Frequency” on page 781.
Type (Step) [Individual, Common1, Common2]
Common LFO Phase Offset [degrees] [+/–180]
These parameters control the LFO source for the steps; they
do not affect the triangle or sine LFOs. For more
information, see “Step LFO type” on page 782.
OUTPUT
Wet/Dry [–Wet… –1:99, Dry, 1: 99…Wet]
Sets the balance between the “wet” processed sound and the
dry input. Negative values invert the phase of the wet signal.
This interacts with Resonance; for more information, see
“Resonance” on page 808.
Source [Off…Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
LFO: Step-Tri/Random
Left
Right
Resonance
LFO Phase
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
Phaser
Phaser