Korg NAUTILUS Series

SEQUENCER mode
512
8–4: Audio Routing2
Here you can specify the buses, effect control bus, and REC
bus for the outputs of audio tracks 1–16.
8–4a: Audio Routing2
Track 01 (Track Number)
STEREO
This is shown if Stereo Pair is on.
Bus Select (IFX/Indiv.Out Assign)
[L/R, IFX1…12, 1…4, 1/2…3/4, Off]
This specifies the bus for the audio track. The current
settings can also be viewed in the Routing Map. This
parameter can also be edited from the IFX– Audio Routing 1
page. For more information, please see “Bus Select
(IFX/Indiv.Out Assign)” on page 507.
FX Control Bus [Off, 1, 2]
Sends the output of the audio track to an FX Control bus
(two-channel stereo FX Ctrl 1 or 2).
For more information, please see “FX Control Bus” on
page 509. For examples, see “FX Control Buses” on
page 733.
REC Bus [Off, 1, 2, 3, 4, 1/2, 3/4]
These settings send the output of the audio track to the REC
buses (four mono channels: 1, 2, 3, 4). For more information,
please see “REC Bus (All OSCs to)” on page 509.
Track 02…16 (Track Number)
Here you can specify the output bus, effect control bus, and
REC bus for audio tracks 2 through 16. These are the same
as for track 1, above.
v 8–4: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Copy Insert Effect →p.122
• Swap Insert Effect →p.122
• Stereo Pair →p.525
• Put Effect Setting to Track →p.554
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
• PAGE →p.126
•MODE →p.126
8–1a
8–4PMC
8–4a
1–1a
1–1b