Dynamics 000: No Effect
761
Dynamics
000: No Effect
Choose this option when you are not using the selected
effects slot. This frees up processing resources for other
effects and/or synth voices.
When a slot is set to No Effect:
• Insert Effects and Total Effects pass through the dry,
unprocessed signal
• Master Effects mute their outputs
001: Stereo Dyna Compressor
On-screen graphic, 001 Stereo Dyna Compressor
This effect reduces the dynamic range of the input signal, to
regulate the level and give a “punchy” effect. It is useful for
guitar, piano, and drum sounds. This is a true stereo effect;
you can link the left and right channels, or use each channel
separately.
ENVELOPE
Select [L/R Mix, L/R Individually]
This determines how the left and right channels of the
selected Source are used for controlling the compressor.
Note that this applies only to the control signal; the effect
always processes both channels of the input signal in stereo.
L/R Mix is generally the best choice for stereo signals; this
compresses both channels equally, based on the combined
volumes of the left and right channels.
L/R Individually splits the effect into two separately
controlled mono compressors. When processing stereo
signals, this will cause the stereo image to shift.
Pre EQ
Trim [0…100]
This sets the input level for the EQ.
LEQ Fc [Low, Mid-Low]
Selects the frequency of the EQ’s low band.
LEQ Gain [dB] [–15.0…+15.0]
Sets the gain of the Low EQ.
HEQ Fc [High, Mid-High]
Selects the frequency of the EQ’s high band.
HEQ Gain [dB] [–15.0…+15.0]
Sets the gain of the High EQ.
COMPRESSOR
Sensitivity [1…100]
This controls the amount of compression. Increasing the
value boosts lower level sounds, and raises the overall
volume.
To adjust the final volume, use the Output Level parameter.
Output Level
(post-Compressor)
Input Level
(pre-Compressor)
Gain Reduction
(controlled by Sensitivity and
input level)
Left
Right
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
EQ Trim
EQ Trim
LEQ HEQ
LEQ
HEQ
Compressor
Compressor
Envelope Select
Output Level
Output Level
Envelope - Control
Envelope - Control
To Next Page
Loading...
Need help?
General
