Chorus, Flanger, and Phaser 040: Stereo Chorus
799
Chorus, Flanger, and Phaser
040: Stereo Chorus
This effect adds thickness and warmth to the sound by
modulating the delay time of the input signal. You can add
spread to the sound by offsetting the phase of the left and
right LFOs from each other.
Pre EQ
Trim [0…100]
Sets the EQ input level.
LEQ Fc [Low, Mid-Low]
Selects the cutoff frequency (low or mid-low) of the low-
range equalizer.
LEQ Gain [dB] [–15.0…+15.0]
Sets the gain of the Low EQ.
HEQ Fc [High, Mid-High]
Selects the cutoff frequency (high or mid-high) of the high-
range equalizer.
HEQ Gain [dB] [–15.0…+15.0]
Sets the gain of the High EQ.
LFO
Waveform [Triangle, Sine]
Selects the LFO Waveform.
Phase [degrees] [–180…+180]
Sets the LFO phase difference between the left and right. See
“Phase [degrees]” on page 781.
Frequency [Hz] [0.02…20.00]
This sets the LFO speed, in Hz. It applies only when
MIDI/Tempo Sync, below, is Off.
Source [Off…Tempo]
This selects a modulation source for the Frequency.
Amount [–20.00…+20.00]
This sets the Frequency modulation amount, in Hz.
MIDI/Tempo Sync [Check-box]
BPM [MIDI, 40.00…300.00]
Base Note [ … ]
Times [x1…x32]
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see “MIDI/Tempo Sync” on page 779.
Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO, or
one of the Common FX LFOs. For more information, see
“LFO Type” on page 779.
Common LFO Phase Offset [degrees] [+/–180]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
CHORUS
L Pre Delay [msec] [0.0…50.0]
Sets the delay time for the left channel. Setting the left and
right delay times to slightly different values allows you to
control the stereo image.
R Pre Delay [msec] [0.0…50.0]
Sets the delay time for the right channel.
Depth [0…100]
Sets the depth of LFO modulation.
Source [Off…Tempo]
Selects the modulation source for the LFO modulation
depth.
Amount [+/–100]
Sets the modulation amount of the LFO modulation depth.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Chorus
Chorus
Left
Right
LFO Phase
Wet / Dry
Wet / Dry
Stereo In - Stereo Out
EQ Trim
EQ Trim
LEQ
HEQ
LEQ
HEQ
LFO: Tri / Sine
To Next Page
Loading...
Need help?
General
