SEQUENCER > MFX/TFX 9–2: MFX1
519
9–2: MFX1
Here you can edit the parameters of the Master Effect 1.
Effects Modulation: Dmod
Most effects have one or more parameters which can be
modulated in realtime. In the NAUTILUS, this is called
Dynamic Modulation, or Dmod for short.
For a complete list of Dmod sources, see “Dynamic
Modulation Source List” on page 910.
You can use different MIDI channels to control Dmod for
each effect, if desired, as selected by the Ch (Control
Channel) parameter.
9–2a: MFX1
MFX1 On/Off [Off, On]
This turns master effect 1 on/off. This is linked with the
on/off setting in the MFX/TFX– Master/Total Effect -
Routing page.
Ch (Control Channel) [Ch01…16, G ch]
Specifies the MIDI channel that will control dynamic
modulation (Dmod) for the master effect.
Ch01…Ch16: The specified MIDI channel will be used for
control.
G ch: The global MIDI Channel (GLOBAL 1–1a) will be
used for control. Normally you will use the G ch setting.
P (Effect Preset) [P00, P01…15, U00…15, ------]
This selects the effect preset.
For more information, please see “Effect preset function” on
page 103.
MFX1 Parameters
Here you can set the effect type parameters selected in the
master effect 1.
For details on the individual effects, please see the “Effect
Guide” on page 729.
v
9–2: Page Menu Commands
• Compare →p.112
• Memory Status →p.521
• Exclusive Solo →p.113
• Copy MFX/TFX →p.125
• Swap MFX/TFX →p.125
• Write FX Preset →p.125
• Put Effect Setting to Track →p.554
• FF/REW Speed →p.523
• Set Location (for Locate Key) →p.523
•PAGE →p.126
•MODE →p.126
To Next Page
Loading...
Need help?
General
