892
188: Black Phase
Inspired by a classic European phaser pedal.
PHASER
Depth [0…100]
Sets the depth of LFO modulation.
Source [List of Dmod Sources]
This selects a modulation source to control the LFO
modulation Depth.
Amount [–100…+100]
This controls the depth and direction of the Depth
modulation.
Resonance [000…100]
This controls the intensity of the phaser effect. Mixing the
processed and dry signals via Wet/Dry will enhance the
effect.
Manual [1…100]
This sets the center frequency of the phaser.
LFO
Speed [Hz] [0.10…10.00]
This controls the speed of the phaser’s LFO.
Source [List of Dmod Sources]
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the “Dynamic Modulation Source
List” on page 910.
Amount [–10.0…+10.0]
This controls the depth and direction of the Speed
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
189: Vintage Chorus
This models a chorus best-known for being built into a guitar
amp. You can use the Speed and Depth for an even broader
range of possibilities than on the original device.
CHORUS
Depth [0…100]
Sets the depth of LFO modulation.
Source [List of Dmod Sources]
This selects a modulation source to control the Depth.
Amount [–100…+100]
This controls the depth and direction of the Depth
modulation.
Manual [1…100]
This adjusts the offset of the LFO sweep, effectively
increasing the center delay time of the chorus.
When Depth is set to the maximum of 100, this has no
effect.
Output Mode [Mono, Stereo]
The chorus can function either in mono or stereo.
LFO
Speed [Hz] [0.10…10.00]
This controls the speed of the chorus’ LFO.
Source [List of Dmod Sources]
This selects a modulation source to control the Speed. For a
list of Dmod sources, see the “Dynamic Modulation Source
List” on page 910.
Amount [–10.0…+10.0]
This controls the depth and direction of the Speed
modulation.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Mono Out / Dry: Stereo In - Stereo Out
+
Phaser
LFO
Resonance
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
+
Chorus
LFO
Output Mode
Mono
Stereo
(L-D&R-W)
To Next Page
Loading...
Need help?
General
