Korg NAUTILUS Series

COMBINATION mode
410
v 2–4: Page Menu Commands
• Compare →p.112
• Write Combination →p.433
• Exclusive Solo →p.113
• Copy From Program →p.433
•PAGE →p.126
•MODE →p.126
2–5: Wave Seq/ARP
Here you can make settings related to wave sequence and
Arpeggiator functionality for each timbre.
2–5a: Wave Sequence/ARP
Timbre 01
Wave Sequence Key Sync [PRG, Off, On]
Specifies the wave sequence Key Sync setting (PROGRAM
1–1e) of the program selected for the timbre. This setting is
valid if the program uses a wave sequence.
PRG: The setting of the program is used.
Off: Key Sync is forced off. The wave sequence of each
note will synchronize to the same step.
On: Key Sync is forced on. The wave sequence will start
each time you press a key. If the wave sequences have
differing steps or rates, they will proceed independently.
Wave Sequence Swing[%] [PRG, –300…+300]
Specifies the wave sequence “Swing%” setting (PROGRAM
1–1e) of the program selected for the timbre. This setting is
valid if the program uses a wave sequence.
PRG: The setting of the program is used.
–300…+300: The Swing% specified here is used regardless
of the program’s “Swing” setting.
For more information, please see “Swing” on page 39.
Wave Sequence Quantize Trigger [PRG, Off, On]
This allows you to override the Program’s Wave Sequence
“Quantize Trigger” setting (PROGRAM 1–1d). If you’re
using multiple Programs with rhythmic Wave Sequences,
you can use this to synchronize all of the Wave Sequences at
note-on.
Note that Quantize Trigger applies only when the Wave
Sequence’s Mode is set to Tempo. For more information, see
“Mode” on page 662.
PRG: The setting of the program is used.
Off: “Quantize Trigger” is forced off. The wave sequence
will trigger immediately after note-on.
On: “Quantize Trigger” is forced on. The wave sequence
pattern will synchronize to eighth-note timing of the
currently-sounding wave sequence; i.e., the trigger will be
quantized.
For more information, please see “Quantize Trigger” on
page 39.
2–5PMC
2–5a
1–1a
1–1b