Korg NAUTILUS Series

Modulation and Pitch Shift 072: Pitch Shift Mod.
827
072: Pitch Shift Mod.
This effect uses an LFO to modulate the pitch shift amount,
and lets you adjust the panning and stereo width between the
effected and dry sounds.
PITCH SHIFTER
Pitch Shift [cents] [+/–100]
Sets the pitch difference from the input signal.
Depth [+/–100]
Sets the LFO modulation depth for pitch shift amount.
Source [Off…Tempo]
Selects the modulation source of the depth of modulation.
Amount [+/–100]
Sets the modulation amount of the depth of modulation.
Pan [L, 1:99…99:1, R]
This simultaneously controls the panning and stereo width
for the pitch-shifted and dry sounds. The value is shown for
the pitch-shifted signal, and the dry signal is always at the
opposite side of the stereo field.
For instance, when Pan is set to L, the effected sound is
panned all the way to the left, and the dry sound is panned all
the way to the right. When Pan is set to R, the panning is
reversed.
Intermediate values decrease the stereo width, so that at
50:50, both sounds are centered.
LFO
Waveform [Triangle, Square]
Selects the LFO Waveform.
Frequency [Hz] [0.02…20.00]
Sets the LFO speed, in Hz.
Source [Off…Tempo]
Selects a modulation source for LFO speed.
Amount [–20.00…+20.00]
Sets the modulation amount of LFO speed.
MIDI/Tempo Sync [Check-box]
BPM [MIDI, 40.00…300.00]
Base Note [ …  ]
Times [x1…x32]
When MIDI/Tempo Sync is on, the LFO speed is set by
BPM, Base Note, and Times, instead of Frequency. For
more information, see “MIDI/Tempo Sync” on page 779.
LFO Type [Individual, Common1, Common2]
Selects either (individual) LFO, Common FX LFO1, or
Common LFO2. p.779.
Common LFO Phase Offset [degrees] [+/–180]
Sets the phase offset when Type = Common 1 or Common 2.
p.779.
OUTPUT
Wet/Dry [Dry, 1:99…99:1, Wet]
Sets the balance between the effect and the dry input. Unlike
most effects, when this is set to Wet, the dry and effected
signals will be heard at equal volume.
Source [Off…Tempo]
Selects a modulation source for Wet/Dry.
Amount [+/–100]
Sets the modulation amount for Wet/Dry.
Left
Right
Wet / Dry
Wet / Dry
Wet: Mono In - Stereo Out / Dry: Stereo In - Stereo Out
LFO: Tri / Sqr
Pan
+
Pitch Shifter
Pitch
Higher
Pitch Shift Mod - Pitch Shift / Depth
Lower
Original Pitch
Pitch Shift (+ value)
LFO Waveform=Triangle
Depth (+value)
LFO Waveform=Square
Depth (–value)