Korg NAUTILUS Series

PROGRAM > Filter 3–5: Filter2
73
When the AMS source is at its maximum value–for instance,
when Velocity is at 127–a setting of +8 will make the Attack
time almost twice as long, and a setting of –8 will cut the
Attack time almost in half.
Decay [–99…+99]
This controls the depth and direction of the AMS modulation
for the Decay time.
Slope [–99…+99]
This controls the depth and direction of the AMS modulation
for the Slope time.
Release [–99…+99]
This controls the depth and direction of the AMS modulation
for the Release time.
AMS2 and AMS3
These select the second and third AMS sources, respectively,
for controlling the EG’s Time parameters. Each has its own
intensities for Attack, Decay, Slope, and Release. The
parameters of both AMS2 and AMS 3 are identical to those
of AMS1, above.
v 3–4: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy Oscillator →p.119
• Swap Oscillator →p.119
• Sync Both EGs →p.121
•PAGE →p.126
•MODE →p.126
3–5: Filter2
This page controls Oscillator 2’s basic filter settings. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–1: Filter1,” on page 62.
3–6: Filter2 Mod.
This page controls Oscillator 2’s filter modulation. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–2: Filter1 Mod.,” on page 65.
3–7: Filter2 LFO Mod.
This page controls Oscillator 2’s LFO filter modulation. It is
available only when the Oscillator Mode is set to Double; if
not, the page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–3: Filter1 LFO Mod.,” on page 69.
3–8: Filter2 EG
This page controls Oscillator 2’s Filter EG. It is available
only when the Oscillator Mode is set to Double; if not, the
page will be grayed out.
The parameters are identical to those for Oscillator 1, as
described under “3–4: Filter1 EG,” on page 70.