PROGRAM: Page Menu Commands Sync Both EGs
121
LEQ Gain [-36dB…+00…+36dB]
This adds to, or subtracts from, the Program’s Low EQ gain
setting. If the EQ is bypassed, this will have no effect.
MEQ Gain [-36dB…+00…+36dB]
This adds to, or subtracts from, the Program’s Mid EQ gain
setting. If the EQ is bypassed, this will have no effect.
HEQ Gain [-36dB…+00…+36dB]
This adds to, or subtracts from, the Program’s High EQ gain
setting. If the EQ is bypassed, this will have no effect.
Sync Both EGs
Sync Both EGs is available on the Filter 1/2 EG and Amp
1/2 EG pages.
This option allows you to edit the EGs of Oscillator 1 and
Oscillator 2 together. When it is checked, editing the Filter
EG of either Oscillator 1 or 2 will change both Filter EGs
simultaneously. Similarly, editing the Amp EG of either
Oscillator will change both Amp EGs.
This option is available only when the Oscillator Mode is
set to Double.
1. Select “Sync Both EGs.”
The LCD screen will indicate “Sync Both EGs,” and the
two EGs will be synchronized.
2. If you no longer want the EGs to be synchronized,
select “Sync Both EGs” once again.
The indication will disappear from the LCD screen.
Swap LFO 1&2
Swap LFO 1 & 2 is available on all of the LFO pages,
except for the Common LFO tab.
This command copies the settings of LFO1 to LFO2, and
vice-versa.
Note: If LFO2 is being used to modulate LFO1, this
command will erase that modulation routing (since the LFOs
cannot modulate themselves).
1. Select “Swap LFO 1&2” to open the dialog box.
2. Press the OK button to execute the Copy or press the
Cancel button if you decide to cancel.
Copy External Scene
This command copies the settings of the scene used by a
specified program, combination, or song.
1. Select “Copy External Scene” to open the dialog box.
2. In “From,” select the copy source mode, bank, and
number.
3. If you selected a combination or song as the copy-
source, select the scene from which you want to copy.
4. In “To,” select the scene to which you want to copy.
5. Press the OK button to execute the Copy or press the
Cancel button if you decide to cancel.
The “Input Channel” and “Output Channel”
(COMBINATION/SEQUENCER P7–1) settings of a
combination or song are not copied.
Copy Scene
This command copies settings for the SCENE 1-4 buttons.
You can use this command when you want to make settings
for a scene based on the other scene settings you edited, or
vice versa.
1. Choose “Copy Scene” to open the dialog box.
2. In “From” select the scene that you wish copy.
3. In “To” select the copy destination scene.
4. To execute the copy, press the OK button. To cancel
without executing, press the Cancel button.
To Next Page
Loading...
Need help?
General
