EXi: AL-1 Analog Synthesizer
178
Intensity Mod AMS [List of AMS Sources]
This selects a secondary AMS modulation source to scale
the intensity of AMS1.
For a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [–99…+99]
This controls the depth and direction of the Intensity Mod
AMS. Even if the main AMS1 Intensity is set to 0, Intensity
Mod AMS can still control the final amount of AMS A over
the full +/-99 range.
For example, if AMS1 is set to the Pitch EG, and Intensity
Mod AMS is set to JS+Y, positive settings mean that
pushing the joystick away from yourself will increase the
intensity of the Pitch EG modulation of LFO Frequency.
AMS2 [List of AMS Sources]
This selects the second modulation source for the LFO
frequency. For a list of AMS sources, see “Alternate
Modulation Source (AMS) List” on page 901.
Intensity [–99…+99]
This controls the amount of modulation from AMS2.
8–2c: Frequency MIDI/Tempo Sync
MIDI/Tempo Sync [Off, On]
On (checked): The LFO will synchronize to the system
tempo, as set by either the Tempo knob or MIDI Clock. The
LFO speed will be controlled by the Base Note and
Multiply parameters, below. All settings for Frequency and
Frequency Modulation will be ignored.
Off (unchecked): The Frequency settings will determine the
speed of the LFO, and the tempo settings will have no effect.
Base Note [ … ]
This sets the basic speed of the LFO, relative to the system
tempo. The values range from a 32nd note to a whole note,
including triplets.
Times (Sync. Times) [01…32]
This multiplies the length of the Base Note. For instance, if
the Base Note is set to a sixteenth note, and Times is set to 3,
the LFO will cycle over a dotted eighth note.
v
8–2: Page Menu Commands
• Compare →p.112
• Write Program →p.112
• Exclusive Solo →p.113
• Copy LFO →p.182
• Swap LFO →p.182
• PAGE →p.126
•MODE →p.126
8–3: LFO 2
8–4: LFO 3
8–5: LFO 4
The settings for LFOs 2-4 are identical to those for LFO1.
For more information, see “8–2: LFO 1” on page 175.