PROGRAM mode: HD-1
126
If sounds within a single bank use multiple KSCs, select the
Current Program option. For instance, some users keep all
sample-related Programs in Bank USER-G, but Program 000
uses Friday.KSC, Program 001 uses Saturday.KSC, and so
on. The Current Program option lets you deal with each
Program individually. There are similar commands for
individual Wave Sequences and Drum Kits; the correct
option will appear for the current mode.
The Current Program option changes the edit buffer, and
is not automatically saved. This lets you use COMPARE
to revert to the original version, if desired. Make sure to
Write the Program if you want to make the remap
permanent. The All Programs etc. and Bank options
changed the stored data directly, and do not require a
separate Write command.
3. Set the From parameter to the old Multisample
and/or Sample bank—the one you’ll be changing to
the new bank.
For instance, if you’re updating sounds from Smp: Old
RAM to a User Sample Bank, set From to Smp: Old
RAM. Only Multisample/Sample banks which are currently
loaded will appear in this list. If In is set to Current, only
banks referred to by the current item will be shown.
4. Set the To parameter to the new Multisample and/or
Sample bank—the one that remapped references will
be changed to.
5. Press the OK button to complete the remapping, or
press the Cancel button to exit without making
changes.
If you press OK, a message appear to show how many bank
references have been changed.
Remapping does not affect Tone Adjust settings,
including any settings in Combinations or Songs.
PAGE
Displays “Page Select”.
MODE
Displays “Mode Select”.
To Next Page
Loading...
Need help?
General
