GLOBAL > Drum Kit 5–1: Sample Setup
671
5–1: Sample Setup
This page lets you assign sounds to each key in the Drum
Kit. A single key is shown at a time. Each key can have up to
8 Drum Samples (DS1–8), and each DS has its own settings
for start offset, reverse on/off, level, and velocity zone. For
additional DS parameters, see “5–2: Sample Parameter” on
page 674 and “5–3: Voice/Mixer” on page 676.
For more information on Drum Kits, see “Using Drum Kits”
on page 190 of the OG.
5–1a: Drum Kit, Key Select, Assign
Drum Kit [A00...39, G00...T15, GM0...GM8]
Selects the Drum Kit that you wish to edit.
When the Drum Kit Select window is open, you can use the
Find button to search for Drum Kits by name. For more
information, see “Find dialog” on page 7.
Drum Kit bank contents
Note: GM0–GM8 are GM2-compatible preset Drum Kits.
As with GM bank Programs, they can be edited but must be
saved to a non-GM location.
KEY [C–1…G9]
Selects the key to which the drum sample (and its settings)
will be assigned.
Use the VALUE controller to specify the key. You can also
select the key by holding down the ENTER button and
playing a note on the keyboard. You can assign up to eight
drum samples (DS1…8) to each key, and switch between
them by velocity.
If you check Assign for the key you select here, the DS1…8,
Voice Assign Mode, and Mixer parameters (see below) will
be used.
Bank Contents
A00...A39,
G00..J.05
Factory Drum Kits
GM 0…8 GM2 Drum Kits
K00...T15 User Drum Kits
Keys to which drum samples are
assigned are shown in red.
“KEY”: The selected key is shown in blue.
You can select a key by holding down the ENTER button and playing the
desired note.
Keyboard range
C4 key
Drum Kit, Key Select, Assign
To Next Page
Loading...
Need help?
General
