Korg NAUTILUS Series

Effect Guide
748
Controlling the Insert Effects via MIDI
Using the Dynamic Modulation (Dmod) function enables
you to control all effect parameters in real-time during
performance from the controllers of the NAUTILUS or a
connected MIDI sequencer. You can also control the Pan
(CC#8), Send1, and Send2 parameters in the same way.
PROGRAM and SAMPLING modes
You can control the parameters on the global MIDI channel.
COMBINATION mode
The IFX– IFX1–12 page lets you specify the control channel
Ch (Control Channel) for IFX1–12. You can choose from
CH01–16, Gch, or All Routed.
Ch01–16: Select this when you want to control each insert
effect from a different channel. An “*” symbol will be
displayed at the right of the MIDI channel Ch01–16 of the
timbre that is routed to each insert effect. If the routed
timbres have different MIDI channel settings, this parameter
is used to specify the channel that will control the insert
effect.
Gch: Select this option if you wish to control the parameters
on the global MIDI channel. This is a common setting.
All Routed: Select this option to control the parameters on
all the channels (channels 1–16 that have a “*” mark) that
are routed to the corresponding Insert Effects.
If you’ve checked “Bus Select DKit” (8–1c) for a timbre
for which a drum program is selected, the MIDI channel
of that timbre will be valid if any IFX1–12 is set to All
Routed, regardless of the drum kit’s Bus Select settings
and the settings of the Drum Kit IFX Patch page menu
command.
SEQUENCER mode
Use “Ch” parameters of the “IFX– IFX1–12” pages to set up
the control channels for IFX1–12. Select an appropriate
option from Ch01–16 and All Routed.
Ch01–16: Select this when you want to control each insert
effect from a different channel. An “*” symbol will be
displayed at the right of the MIDI channel Ch01–16 of the
track that is routed to each insert effect. If two or more tracks
with differing MIDI channels Ch01–16 are being sent to a
single insert effect, this parameter is used to specify the one
track that will control the insert effect.
All Routed: Select this option to control the parameters on
all the channels (channels 1–16 that have a “*” mark) that
are routed to the corresponding Insert Effects. “All Routed”
is a typical option. If you wish to control the parameters on a
single channel, you may select it from Ch01–16.
If you’ve checked “Bus Select DKit” for a track for
which a drum program is selected, the MIDI channel of
that track will be valid if any IFX1–12 is set to All
Routed, regardless of the drum kit’s Bus Select settings
and the settings of the Drum Kit IFX Patch page menu
command.
Note: Since SEQUENCER mode lets you record and play
exclusive messages and edit tracks that include System
Exclusive events, you can use them to switch effects or
modify effect parameter values during song playback.