EXi PROGRAM > EP-1: Panel/IFX/Amp Reed EP
369
Reed EP
These parameters apply when the EP Model Type is set to
either Reed 200 or Reed 200a.
5–1i: Pre-amp
VOLUME [00.0…10.0]
This controls the volume level. The default is 8.0.
AMS [List of AMS Sources]
This selects an AMS source to control the VOLUME. For a
list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [–10.0…+10.0]
This controls the depth and direction of the VOLUME AMS
modulation.
5–1j: Vibrato
INTENSITY [00.0…10.0]
This controls the depth of the vibrato effect. To turn off the
vibrato completely, set INTENSITY to 00.0. (The original
instrument had only a knob, without a separate on/off
switch.)
AMS [List of AMS Sources]
This selects an AMS source to control the INTENSITY. For
a list of AMS sources, see “Alternate Modulation Source
(AMS) List” on page 901.
Intensity [–10.0…+10.0]
This controls the depth and direction of the INTENSITY
AMS modulation.
SPEED [00.0…10.0]
This controls the rate of the vibrato effect. On the original
instrument, SPEED wasn’t adjustable; 5.0 on this knob
matches the original value.
AMS [List of AMS Sources]
This selects an AMS source to control the SPEED. For a list
of AMS sources, see “Alternate Modulation Source (AMS)
List” on page 901.
Intensity [–10.0…+10.0]
This controls the depth and direction of the SPEED AMS
modulation.
5–1k: Amp & Cabinet
This section is the same as for the Tine Piano, as described
under “5–1h: Amp & Cabinet” on page 368.
5–1PMC
5–1a
5–1i
5–1j
5–1c
5–1d
5–1h
5–1b
To Next Page
Loading...
Need help?
General
