Chorus, Flanger, and Phaser 042: St. Bi-phase Modulation
801
042: St. Bi-phase Modulation
This stereo chorus effect adds two different LFOs together.
You can set the Frequency and Depth parameters for each
LFO individually. Depending on the setting of these LFOs,
very complex waveforms will create an analog-type,
unstable modulated sound.
MODULATION
L Pre Delay [msec] [0.0…50.0]
Sets the delay time for the left channel. p.799.
R Pre Delay [msec] [0.0…50.0]
Sets the delay time for the right channel. p.799.
Depth1 [0…100]
Sets the depth of LFO1 modulation.
Depth2 [0…100]
Sets the depth of LFO2 modulation.
Source [Off…Tempo]
Selects the modulation source of LFO1&2 modulation
depth.
Amount1 [+/–100]
Sets the modulation amount of LFO1 modulation depth.
Amount2 [+/–100]
Sets the modulation amount of LFO2 modulation depth.
Feedback [+/–100]
Sets the feedback amount. See “Feedback” on page 800.
High Damp [%] [0…100]
Sets the amount of high-frequency attenuation.
LFO1/2
LFO1 Waveform [Triangle, Sine]
Selects the waveform for LFO1.
LFO2 Waveform [Triangle, Sine]
Selects the waveform for LFO2.
Phase Sw [0 degree, 180 degree]
This lets you invert the LFO phase between the left and right
channels.
LFO1 Frequency [Hz] [0.02…30.00]
This sets the speed of LFO1, in Hz.
LFO2 Frequency [Hz] [0.02…30.00]
This sets the speed of LFO2, in Hz.
Source [Off…Tempo]
Selects a source to modulate the speeds of LFO1 & 2.
LFO1 Amount [–30.00…+30.00]
This sets the LFO1 Frequency modulation amount, in Hz.
LFO2 Amount [–30.00…+30.00]
This sets the LFO2 Frequency modulation amount, in Hz.
LFO1 Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO1, or
one of the Common FX LFOs. For more information, see
“LFO Type” on page 779.
Common LFO Phase Offset [degrees] [+/–180]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
LFO2 Type [Individual, Common1, Common2]
This controls whether the effect uses its individual LFO2, or
one of the Common FX LFOs. For more information, see
“LFO Type” on page 779.
Common LFO Phase Offset [degrees] [+/–180]
When Type is set to Common FX LFO 1 or 2, this lets you
offset the phase from the master LFO.
OUTPUT
This is the standard effects output section, with modulatable
control over wet/dry balance. For more information, see
“OUTPUT” on page 762.
Chorus/Flanger
Left
Right
Feedback
180 [degree]
Wet / Dry
Wet / Dry
High Damp
Stereo In - Stereo Out
LFO1: Tri / Sine
LFO2: Tri / Sine
Chorus/Flanger
High Damp
LFO1
LFO2
Bi-Phase Modulation LFO
Depth1
Depth2
+
To Next Page
Loading...
Need help?
General
