Korg NAUTILUS Series

SAMPLING mode
600
8–9: Common FX LFO
The two Common FX LFOs allow you to synchronize LFO-
based modulation for multiple effects, such as phasers,
flangers, filters, and so on.
The Common LFOs control only the frequency, MIDI
synchronization, and reset options; each individual effect
still has its own settings for the LFO waveform and phase.
Within the individual effects, you can choose whether to use
one of the Common LFOs, or to use the individual effect’s
frequency, sync, and/or reset settings instead. This is done
via the effect’s LFO Type parameter; select Individual to
use the effect’s settings, or Common 1 or 2 to use the
Common LFOs.
Dmod (Dynamic Modulation) is controlled on the global
MIDI channel specified in GLOBAL mode MIDI page.
 (Tempo) [040.00…300.00, EXT]
This specifies the tempo. This setting is used for controlling
effects, etc.
8–9a: Common FX LFO1
Frequency [0.02…20.00 (Hz)]
Sync (Reset) [Off, On]
Src (Dmod Src) [List of Dmod Sources]
MIDI/Tempo Sync [Off, On]
BPM [MIDI, 040.00…300.00]
Base Note [ …  ]
Times [01…32]
These parameters are the same as in PROGRAM mode. See
“8–9a: Common FX LFO1” on page 105.
8–9b: Common FX LFO2
The parameters are identical to those for Common FX LFO1.
v 8–9: Page Menu Commands
• Copy Insert Effect →p.122
• Swap Insert Effect →p.122
• PAGE →p.126
•MODE →p.126
8–5b
8–5PMC
8–5a
8–1d