SEQUENCER > IFX 8–5: Insert FX
513
8–5: Insert FX
8–5a: IFX
Here you can choose the type of each insert effect 1 through
12, its on/off status, chaining, and adjust the post-IFX mixer
settings. Meters below the IFX labels display the effect
output levels in realtime, showing the combined peak signals
of the left and right channels.
For insert effects, the direct sound (Dry) is always stereo-in
and out. The input/output configuration of the effect sound
(Wet) depends on the effect type. For descriptions of the
individual effects, please see “Effect Guide,” beginning on
page 729.
The following parameters are the same as in PROGRAM
mode. For details, see “8–5a: IFX” on page 101.
However, unlike in PROGRAM mode, insert effect dynamic
modulation (Dmod) and the post-IFX Pan (CC#8), Send1,
and Send2 are controlled on the MIDI channel specified by
“Ch” (8–7a). The control changes used are the same as in
PROGRAM mode.
The pan (CC#8), send 1 and 2 settings you make here will be
used when the song is played or recorded from the
beginning. If you change the settings while recording a
MIDI track, the changes will be recorded as part of the
musical data, and the settings will change when the data is
played back. You can also change these settings during
playback. However if pan (CC#8), send 1, or 2 data has been
recorded, the settings will change accordingly.
If Status (2–1a) is either INT or Both, CC#8, CC#93, and
CC#91 can be received to control the pan following the
insert effect, send 1, or send 2 respectively, and change
their settings. When you switch songs or return to the
beginning of the song, tracks whose Status is Both, EXT,
or EX2 will transmit these settings via MIDI. This data
will be transmitted on the MIDI channels specified in the
IFX 1–12 pages (8–7).
IFX1
IFX1 [000…197]
IFX1 On/Off [Off, On]
Chain to [IFX2…IFX12]
Chain [Off, On]
Pan(CC#8)
(Post IFX PanCC#8)
[L000…C064…R127]
Bus Sel. (Bus Select) [L/R, 1…4, 1/2…3/4, Off]
Ctrl Bus (FX Control Bus) [Off, 1, 2]
REC Bus [Off, 1, 2, 3, 4, 1/2, 3/4]
Send1 [000…127]
Send2 [000…127]
IFX2…12
These parameters specify the type of each insert effect, its
on/off status, chaining, and post-IFX mixer settings. With
the exception of Chain to and Chain, the parameters are the
same as for IFX1. For more information, please see “IFX1”
on page 101.
To Next Page
Loading...
Need help?
General
