Korg NAUTILUS Series Parameter Guide

MS-20EX: Tone Adjust Common Tone Adjust parameters
279
MS-20EX: Tone Adjust
MS-20EX Tone Adjust Default Settings
Tone Adjust provides an elegant physical interface to the
MS-20EX’s parameters. Most of the factory sounds use the
default layout, as shown above. You can also customize the
layout for individual sounds, if desired.
For more information about Tone Adjust, please see “0–9a:
Tone Adjust,” on page 29.
Common Tone Adjust parameters
These parameters affect both EXi 1 and 2. Except as noted
below, the Common Tone Adjust parameters behave as
described under “Common Tone Adjust Parameters,” on
page 31.
Filter Cutoff. (–99…+99, CC#74)
This scales the cutoff frequency of the lowpass filter. To
adjust the highpass filter, use the separate, MS-20EX-
specific Tone Adjust parameters.
Filter Resonance. (–99…+99, CC#71)
This scales the resonance (PEAK) of the lowpass filter. To
adjust the highpass filter, use the separate, MS-20EX-
specific Tone Adjust parameters.
Filter EG Intensity. (–99…+99, CC#79)
This scales the EG2/EXT knob for the lowpass filter.
Amp Velocity Intensity. (–99…+99)
Not supported.
Filter/Amp EG Attack Time.
(–99…+99, CC#73)
This scales the attack time of EG2, which is normalled to
both filter cutoff and amplitude.
VCO2
Waveform
HPF
Cuto
HPF
Peak
HPF
EG2/Ext Mod
LPF
Frequency
LPF
Peak
LPF
EG2/Ext Mod
VCO1
Waveform
EG1
Attack
EG1
Release
EG2
Attack
EG2
Decay
EG2
Sustain
EG2
Release
MG
Waveform
MG
Freq/Times
EG1
Delay
Button 7, 8, 15, 16:
LFO 1, 2, 3, 4 Stop

Korg NAUTILUS Series Specifications

General

Sampling	Open Sampling System
MIDI	In, Out, Thru
Preset Combinations	384
Keyboard	61-key (NAUTILUS 61), 73-key (NAUTILUS 73), 88-key (NAUTILUS 88, RH3 weighted action)
Effects	12 Insert Effects; 2 Master Effects; 2 Total Effects
Sequencer	16-track MIDI Sequencer
Storage	Internal SSD (60 GB)
Audio Inputs	2 x 1/4"
Audio Outputs	Headphones
USB	Type A (host), Type B (device)
Weight	NAUTILUS 88: 23.1 kg
Display	8 inch TouchView™ GUI (800x600 pixels)