EXi: STR-1 Plucked String
248
PROGRAM > STR-1: EG 1-4
The STR-1 has four assignable EGs, in addition to the Amp
EG. Each of these can be used as an AMS modulation source
to control a wide variety of parameters.
There are also two parameters with dedicated EG
modulation inputs: Frequency for Filters A and B. Any of
the four EGs can be used for these modulation routings.
In the midst of all this flexibility, we thought it would also be
good to provide a little structure. With this in mind, EG 1 is
named EG 1 (Filter), and EG2 is named EG 2 (Pitch).
Please take these names as suggestions, rather than
restrictions. If you like, you’re free to use these envelopes to
control any EG or AMS destination, or to use other EGs to
control Filter Frequency or Pitch.
7–1: EG 1 (Filter)
7–2: EG 2 (Pitch)
7–3: EG 3
7–4: EG 4
The STR-1’s EGs 1-4 are identical to the AL-1’s EG1. For
detailed explanations, please see “7–1: EG 1 (Filter),” on
page 169.
PROGRAM > STR-1: LFO 1-4
The STR-1 has four assignable LFOs, in addition to the EXi
Program’s Common LFO. Each of these can be used as an
AMS modulation source to control a wide variety of
parameters.
8–1: LFO 1
8–2: LFO 2
8–3: LFO 3
8–4: LFO 4
The STR-1’s LFOs 1–4 are identical to those of the AL-1.
For detailed explanations, please see “8–2: LFO 1,” on
page 175.
To Next Page
Loading...
Need help?
General
